PDR stands for paintless dent repair. It’s a craft that you can learn and it will, once you have mastered the skill, be a way for you to earn a very nice income. You will be able to remove those dings from car doors, and other small dents that you will find around the automobile. This doesn’t take long if you are experienced at doing it. It normally takes 10 to 20 minutes and is very inexpensive, since there is no product to buy. PDR is becoming the alternative to body shops in Fountain .
The biggest reason people are choosing this method over a body shop is the time that it takes at a body shop to repair a dent, and also the money they are spending to get it fixed. With PDR, not only will the time your vehicle is being repaired be shorter, but also it will cost you so much less money. It’s a new way of fixing dents and dings that is putting the car repair world at notice!
How exactly does paintless dent repair work? A person who has been trained at PDR will use metal rods and picks in order to massage out dents and dings from the finish of the car. This will be done by the expert working from the inside of the car or panel, depending on where the dent or ding is. In essence, the dings and dents are being pushed out. A normal repair from beginning to end will last about 10 to 20 minutes.
If you want to try and do this as a living all you need is to purchase the tools, get the training, and offer a service where you will go to people and fix the dents and dings, or get a shop and do the service from there. This is a very high-demand service in Fountain that many people are looking to have done now. It depends on where the dent or ding is in the vehicle and how you will access it. Here are some of the more common areas and how to go about accessing it.
Doors: You will need to roll down the window, and access the area by the window ledge opening. There may be an existing opening in the door jam. Access through this spot. Take the panel off the door, or even drill a hole in the door. You can finish this off by putting a silicone plug into the hole to prevent any corrosion, and to make the door look good.
Rear quarter panels: There should be an opening or even a vent in the rear door area. Access through this spot. Go through the trunk, or through a tail light assembly. You can access the dent through the wheel well, or drill a hole through the rear door. Of course, you will need to plug it when finished.
Roof: simply remove or lower the headliner.
Front fender: go through the engine compartment, or through a headlight assembly. Again you could access this from the inner wheel well too.
Hood: remove the covering from the inside of the hood and access the ding or dent this way.
While doing these repairs, it should not require the technician to drill any holes.
Does PDR Work?
Owing to the reasons that paintless dent repair is fast and efficient it is quickly becoming popular. But there is a dearth of trained professional technicians who are skilled in the techniques that are required for this trade. If after training you want to start your own business then here are some tips to keep in mind when starting your Paintless Dent Repair (PDR) Business.
1. Survey the Market:
It is very important that you consider your potential market. Decide who you will work with? Do you have any connections at a body repair shop, wholesalers, car dealer, detail shop, service centre, etc who will hire you once you complete your paintless dent removal course?
2. Survey your Competition:
Collect information about how many paintless dent removal technicians there are in your area and how are they operating in your potential market. What are the charges for their services and what kind of a relation does your competition have with your potential market as well. Note all these things down for reference.
3. Register your Business:
Check out your state government's website and get information about how to register your business. Make sure that you choose a business name that connects you to the paintless dent repair industry and you could even use the words like dents, dings, dent repair, etc. Complete the entire registration process or even get some professional help.
4. What are your State's Requirements?
The rules and regulations vary from state to state and so it is important that you are completely aware of all the requirements for setting up a PDR Business. You may need business insurance, sales license, shop space, etc. You could ask a local dealer or the office manager of a PDR company what their dealers require from their vendors that is you.
5. Get Trained and buy the Tools:
You need to get trained at a very good academy so that you are well versed in the techniques and skills required in this business. You could consider the name Dents R Us for your paintless dent removing training. For more info check them out at http://www.dentsrus.com.au. You will also need to buy your tools for the job and you need to practice as much as possible.
6. Get Business Material:
You will need office stationery, business cards, invoices, etc and even some accounting material.
7. Don't quit your Current Job!
It is important that you keep your current job as you will need some income to support the business and the family till you are really on your way.
8. Practice on your Acquaintances:
As you begin your business you will need as much practice as you can get and one of the best ways is to practice with the cars belonging to your connections and acquaintances. Of course not many people will hand over the keys to their BMWs, until you are sure of your skills but till then you can even ask your local body shop to give you some work for no pay.
9. Pitch yourself:
You need to be your best marketing strategy. You need to start talking about your work to potential clients or people who will get you work. You need to show them what you are capable of and you need to convince them that you are only getting better and it is YOU that is working for them. Be responsible and you will get recommendations.
Last but not the least, finalise your legal businesses and tie up the loose ends in regards to conducting your business as a vendor to body shops to dealerships.
These are few things you could keep in your mind when starting out. Hopefully they have been of some help.
The long arm of car repair insurance doesn't stop at extended warranties or tire road hazard insurance. Marketing gurus have found all sorts of knick knacks to insure. Among the top are ding and dent protection plans. Ding and dent insurance is growing steadily, and addresses those unsightly shopping cart and parking lot dings.
Dings and dents are fairly synonymous terms, although a ding is smaller than a dent. You'll notice a dent. You'll need to squint, or catch the vehicle in the right angle or sunlight to see a ding. Some dings are smaller than eraser heads.
Like extended warranties or tire insurance, dent and ding protection plans promise to pay for damages in part or in full for a specific period of time. These plans are primarily sold by new car dealerships and cost a few hundred dollars.
Ding and Dent Repair: Paintless Dent Repair
Ding and dent repair is called PDR, short for Paintless Dent Repair. There are many companies that perform this service: Ding Doctor, Ding King, No Dents, Dent Wizard...the list goes on. Some are better then others, although ultimately it's up to the skill of the PDR technician. Prices are similar.
How is it done?
Most PDR techniques are non-intrusive. The PDR technicians use specially designed tools and gadgets to slip behind the damaged panels and manipulate and massage the damaged metal back to its original form.
Does it work?
Actually, it's incredible! It works so well that in the majority of cases the dings and dents are completely removed. They're invisible, gone, can't-believe-your-eyes fixed.
I saw a soccer-ball-sized dent removed from the rear fender of a $120,000 car. The dent also had a large crease, which makes repairs even harder. After thirty minutes there was no visible detection that a dent was ever there. The repair cost the client $400. Traditional body shop estimates were hovering at $2700.
- Very low cost compared to traditional body shops
- Same day repairs--even while-you-wait service
- No paint work, sanding, or traditional bodywork required
- Original paint remains--helps retain vehicles looks and value
- Body panels remain intact--maintaining structural integrity
- PDR does not address scratches or paint chips that are often associated with dings (Many PDR companies will address chips and scratches, but it's not PDR technology)
- Many areas of body panels are not accessible, so PDR is not an option
- Plastic bumpers or any plastic components can't be fixed with PDR techniques. Since the bumper is the most common area to get damaged, this is a significant downside of PDR technology.
- Some damage can occur to door panels, paint, interiors, window glass and hardware, although damage of any kind is rare.
Should you get your dings fixed using PDR techniques?
Let me explain...
Insuring against dings and dents does not make economic sense. Ding repairs average around $50 per ding. Some dings cost $99 to $149 to repair. Two to four dings can run $100 to $450, depending on the size of the dent. Insurance at this level is just not necessary. Moreover, it's a gamble you will lose.
To benefit from a $300, two-year plan, your vehicle would need to sustain multiple "PDR repairable" dings or dents. Despite your coverage, you may not even notice the dings, making a claim impossible. Also, despite the amazing PDR techniques, they can't fix everything, especially the chips and scratches that so frequently accompany a ding--should dings even occur.
Yes, get your dings fixed with PDR (if they're bothering you), but don't buy an insurance plan.
Protection plan economics 101
An article by Terence O'Hara in the Washington Post is a wonderful piece on the insanity of protection plans, and is applicable here. He writes:
The decision to buy an extended warranty...defies the recommendations of economists, consumer advocates and product quality experts, who all warn that the plans rarely benefit consumers and are nearly always a waste of money.
'[Extended warranties and protection plans] make no rational sense,' Harvard economist David Cutler said. 'The implied probability [of an issue] has to be substantially greater than the risk that you can't afford to fix it or replace it. If you're buying a $400 item, for the overwhelming number of consumers that level of spending is not a risk you need to insure under any circumstances.'
...extended warranties play upon a basic human trait to avoid loss, even if it means sacrificing a possible future gain. In this case, the gain is all the other things of value that a consumer could buy with the money that was spent on a warranty
Fix your dings
Fix your dings and dents (if you want) as they come--maybe every spring. Fixing dings keeps your car looking pristine, and increases its value. But don't bother with a protection plan. Save your money.
Hold off on that paint job
Quality paintless dent repair is often a great substitute for those considering full paint jobs. Whenever possible, it's best to keep the original paint. Good PDR combined with a professional detail can restore vehicles to show room condition for less than $500.
Go with the best
Since 1983 Dent Wizard has been pioneering PDR technology. Their PDR technicians undergo extensive and ongoing training. The rates are reasonable and the quality is excellent. Always request a master PDR technician, as there are various levels of abilities.
Check with local dealers
Dealerships in your area may offer Dent Wizard. Your vehicle does not have to be of the same make as the dealership. In other words, you can bring your Chevy to a Ford dealer for PDR work.
Do it yourself paintless dent repair is easy.
No it 's not. It requires training, skill, and experience. There are many who practice PDR techniques who crack or flake the paint, or who create ripples in the metal.
The PDR products sold on TV do the same thing.
No! Not even close. There's no good substitute for the art of PDR.
Scratch and dent repair are the same thing.
No. A ding is a small dent, which can often be repaired via paintless dent repair procedures. A scratch is an actual break in the surface of the clear coat or paint, requiring traditional body shop techniques, or touch up paint.
It's easy to learn how to repair dents on cars.
Maybe for some, but it's a skill that few master. Dent Wizard offers a great training program. The management and staff are top notch.
What's the best car dent removing protection plan?
Money in your bank account!